Turbulent flux and meteorological measurements during ARCTEX-2006 campaign

This dataset present result from the DFG- funded Arctic-Turbulence-Experiment (ARCTEX-2006) performed by the University of Bayreuth on the island of Svalbard, Norway, during the winter/spring transition 2006. From May 5 to May 19, 2006 turbulent flux and meteorological measurements were performed on the monitoring field near Ny-Ålesund, at 78°55'24'' N, 11°55'15'' E Kongsfjord, Svalbard (Spitsbergen), Norway. The ARCTEX-2006 campaign site was located about 200 m southeast of the settlement on flat snow covered tundra, 11 m to 14 m above sea level. The permanent sites used for this study consisted of the 10 m meteorological tower of the Alfred Wegener Institute for Polar- and Marine Research (AWI), the international standardized radiation measurement site of the Baseline Surface Radiation Network (BSRN), the radiosonde launch site and the AWI tethered balloon launch sites. The temporary sites - set up by the University of Bayreuth - were a 6 m meteorological gradient tower, an eddy-flux measurement complex (EF), and a laser-scintillometer section (SLS). A quality assessment and data correction was applied to detect and eliminate specific measurement errors common at a high arctic landscape. In addition, the quality checked sensible heat flux measurements are compared with bulk aerodynamic formulas that are widely used in atmosphere-ocean/land-ice models for polar regions as described in Ebert and Curry (1993, doi:10.1029/93JC00656) and Launiainen and Cheng (1995). These parameterization approaches easily allow estimation of the turbulent surface fluxes from routine meteorological measurements. The data show: - the role of the intermittency of the turbulent atmospheric fluctuation of momentum and scalars, - the existence of a disturbed vertical temperature profile (sharp inversion layer) close to the surface, - the relevance of possible free convection events for the snow or ice melt in the Arctic spring at Svalbard, and - the relevance of meso-scale atmospheric circulation pattern and air-mass advection for the near-surface turbulent heat exchange in the Arctic spring at Svalbard. Recommendations and improvements regarding the interpretation of eddy-flux and laser-scintillometer data as well as the arrangement of the instrumentation under polar distinct exchange conditions and (extreme) weather situations could be derived.

Geochemistry of Lau Backarc Basin sediments

Major and minor (Mn, Sr, Ba, V, Cr, Ni, Co, Zn, Cu, Zr, Y, Sc) elements and mineralogic compositions were determined on bulk sediments collected during Ocean Drilling Program Leg 135. Three classes of sediment samples from holes drilled in the Lau Basin are discriminated by mineralogy and major element data. Samples labeled Class 1 are significantly enriched in biogenic calcite and occur predominantly in the northern part of the basin (Sites 834-835), whereas those of Class 3 are mostly enriched in volcanogenic material and are predominant in the central part of the basin (Sites 836-839). The minor element composition records the effects of the hydrothermal activity on the sediments. In the northern area of the basin (Sites 834-835), sedimentation is characterized by higher accumulation rates of the carbonate and hydrothermal fractions. These sediments are probably reworked predominantly, transported in the water column, and then settled locally. Thus, ponded sediments are probably responsible to this high accumulation rates. Diagenetic processes altered the volcanic material to a grade corresponding to the stability of phillipsite. In the central area of the basin (Sites 836-839), sedimentation is characterized by the action of bottom currents preferentially reworking the carbonate and hydrothermal fractions. Volcanogenic accumulation rates are greater at these sites than in the northern Lau Basin. Alteration of volcanic material is more important deeper in the holes and records authigenesis of clay rich in Fe-Mg, most likely smectite. Locally, clay minerals have apparently incorporated Cr and other ore-forming elements.

Measurements of formation, degradation, and sinking velocity of diatom aggregates from laboratory studies performed at 15 °C and 4 °C

Most deep ocean carbon flux profiles show low and almost constant fluxes of particulate organic carbon (POC) in the deep ocean. However, the reason for the non-changing POC fluxes at depths is unknown. This study presents direct measurements of formation, degradation, and sinking velocity of diatom aggregates from laboratory studies performed at 15 °C and 4 °C during a three-week experiment. The average carbon-specific respiration rate during the experiment was 0.12 ± 0.03 at 15 °C, and decreased 3.5-fold when the temperature was lowered to 4 °C. No direct influence of temperature on aggregate sinking speed was observed. Using the remineralisation rate measured at 4 °C and an average particle sinking speed of 150 m d**-1, calculated carbon fluxes were similar to those collected in deep ocean sediment traps from a global data set, indicating that temperature plays a major role for deep ocean fluxes of POC.

Global Homogeneous Response Units

The concept of homogenous response units (HRU) was designed as a general concept for the delineation of basic spatial units. Only those characteristics of landscape, which are relatively stable over time (even under climate change) and largely unsusceptible to anthropogenic influence, were selected. The HRU can be seen as a basic spatial framework for the implementation of climate change and land management alternative scenarios into global modeling and therefore is a basic input for delineation of landscape units. HRUs are defined based on classifications of altitude (five classes: 1 (0 - 300m), 2 (300 - 600m), 3 (600 - 1100m), 4 (1100 - 2500m), 5 (> 2500m)), slope (seven classes(degrees): 1 (0 - 3), 2 (3 - 6), 3 (6 - 10), 4 (10 - 15), 5 (15 - 30), 6 (30 - 50), 7 (> 50)) and soil composition (five classes: 1 (sandy), 2 (loamy), 3 (clay), 4 (stony), 5 (peat)). e.g. HRU111 refers to Altitude class 1: 0-300m; Slope class 1: 0-3 degrees; and Soil class 1: sandy. Areas of non-soil are assigned 88. HRUs have a spatial resolution of approximately 10 km**2.

Macrofauna abundance and sediment characteristics during R/V Senckenberg cruise west of Sylt in september 2010

The continuously influence of human impacts on the seafloor and benthic habitats demands the knowledge of clearly defined habitats to assess recent conditions and to monitor future changes. In this study, a benthic habitat dominated by sorted bedforms was mapped in 2010 using biological, sedimentological and acoustic data. This approach reveals the first interdisciplinary analysis of macrofauna communities in sorted bedforms in the German Bight. The study area covered 4 km², and was located ca. 3.5 km west of island of Sylt. Sorted bedforms formed as sinuous depressions with an east west orientation. Inside these depressions coarse sand covers the seafloor, while outside predominantly fine to medium sand was found. Based on the hydroacoustic data, two seafloor classes were identified. Acoustic class 1 was linked to coarse sand (type A) found inside these sorted bedforms, whereas acoustic class 2 was related to mainly fine to medium sands (type B). The two acoustic classes and sediment types corresponded with the macrofauna communities 1 and 2. The Aoinides paucibranchiata-Goniadella bobretzkii community on coarse sand and the Spiophanes bombyx - Magelona johnstonii community on fine sand. A transitional community 3 (Scoloplos armiger - Ophelia community), with species found in communities 1 and 2, could not be detected by hydroacoustic methods. This study showed the limits of the used acoustic methods, which were unable to detect insignificant differences in the fauna composition of sandy areas.